Oct 9, 2026 · 7 min read · by TrueMid Manufacturing
When a CNC machining quote comes back twice what you expected, the machine shop's hourly rate is rarely the reason. Machining cost is mostly time on the machine — and your design decisions control that time. These seven changes are the ones we recommend most often when reviewing customer files.
If your part is 52mm thick but plate stock comes in 50mm, you've just bought 100mm stock and paid to machine half of it away. Check standard plate and bar sizes for your material before finalizing outer dimensions. In aluminum, common plate steps are 6, 10, 12, 20, 25, 50mm. An 8mm dimension change at design time can cut material cost 40%.
Tolerance is not a global setting. A ±0.05mm bore on a bearing seat is engineering; the same tolerance on the outer profile of a bracket is charity to the inspection department. Every tight tolerance adds setups, slower feeds, and measurement time.
Every time a part flips over in the vise, you pay for re-fixturing, re-indicating, and a fresh program. A part machined complete in one setup can cost 30–50% less than the same part needing three. Design cues:
Our aerospace bracket case study is a good example — two setups, datum-referenced, no third flip.
A square internal corner requires a smaller tool, slower feeds, and more passes — or EDM. An end mill is round, so internal corners are round. Design internal corner radii at least 1/3 to 1/2 the depth of the pocket, and use a single generous radius where space allows. Bonus: it makes the part lighter and looks intentional.
Deep pockets need long tools that chatter, forcing conservative cuts and multi-pass roughing. Keep pocket depth under 3–4× tool diameter where possible. Thin walls (below ~1.5mm in aluminum) flex under cutting forces, requiring light passes and sometimes custom fixturing — both billed to you. Add ribs or increase wall thickness instead.
The first part absorbs programming and setup cost alone. The tenth part costs barely more than material and cycle time. Real numbers from a typical aluminum bracket:
| Quantity | Unit price index | What you're paying for |
|---|---|---|
| 1 | 100% | Setup + programming dominate |
| 5 | ~45% | Setup amortized across 5 |
| 25 | ~28% | Batch fixturing, continuous runs |
| 100 | ~20% | Consider whether injection molding is now cheaper per part |
If your demand justifies it, the crossover from machining to molding usually lands somewhere between a few hundred and a few thousand units — worth calculating before every production run.
We run DFM review on every file before quoting — no charge, no obligation. Half the time the quote drops just from fixing two or three items above. Send your STEP file through our CNC machining service page and see what changes.
Free DFM review, process recommendation, and detailed quote within 12 hours.
Request a Quote →